With the Entrance App, a QR code is displayed on a screen at the workplace entrance (for example, a tablet, laptop or monitor). Employees scan it with the Factorial mobile app to clock in and out and, if you require it, to start and end their breaks.
Before you start
- Company subdomain required: the Entrance App runs on your company's public link. If your company doesn't have a subdomain yet, you'll be asked to set one up when you turn on the Entrance App. If you close that window without saving, the Entrance App and Require QR codes scan for breaks are switched off again.
- Mobile clock in/out must be on, because employees scan the code with the mobile app.
- Not compatible with geolocation: the Entrance App and Use geolocation can't be on in the same policy. Turning one on turns the other off. If you need the QR code at the office and geolocated mobile clock-ins elsewhere, use separate policies.
To activate the Entrance App
- On your sidebar, go to Settings
- In the Time section, select Time tracking
- Click the arrow next to the policy you want to configure
- In Time tracking system, turn on Mobile clock in/out
- Turn on Entrance App
- Click Copy link and open the Entrance app URL in a browser on the device at the entrance

Treat the Entrance app URL like a password. Anyone with the link can display a valid QR code, so only open it on your company's entrance devices.
Set up the entrance device with a QR code
Instead of copying the link, you can click QR code setup. A QR code appears on your screen: scan it with the entrance device (for example, a tablet's camera) to open the Entrance app URL directly on it.

How the QR code works
- The QR code on the entrance screen refreshes automatically every few seconds, so a photo or copy of the code stops working shortly after it's taken.
- There's no session to expire: the entrance page can stay open on the device.
- QR clock-ins always need an internet connection. Even if your company uses offline clock-in in the mobile app, a QR scan is refused while the phone is offline.
Generate a new link
If you think the link has been shared outside the entrance device, generate a new one:
- In the policy, go to Time tracking system > Entrance App
- Click Generate new link
- Confirm with Generate new link
- Open the new link on every entrance device

The QR code, Clock in by ID and face recognition use the same access code. Generating a new link updates it for all three, in all your policies. Printed QR codes, saved links and configured devices using the old link stop working until you open the new link on them.
How employees clock in/out with the QR code
- Open the Factorial app on your phone
- Tap Clock in. The camera opens automatically
- Scan the QR code displayed at the entrance
- To finish your shift, tap Clock out and scan the QR code again

Require the QR code for breaks
You can also require employees to scan the QR code to start and end their breaks.
- In the policy, go to Time tracking system
- Make sure Mobile clock in/out and Entrance App are on
- Turn on Require QR codes scan for breaks
This only applies to manual breaks. Automatic breaks aren't affected.
For employees:
- Tap Clock in and scan the QR code to start your shift
- When you take a break, tap Break and, if there's more than one break type, choose the type
- Scan the QR code to start the break
- When the break is over, tap End break and scan the QR code again
- At the end of the day, tap Clock out and scan the QR code
Good to know
- Turning off Mobile clock in/out also turns off the Entrance App and Require QR codes scan for breaks.
- If an employee's QR scan fails, check that they have an internet connection and that the entrance device is showing the current link.
- Learn more about time tracking systems